Modele Stratos FPV
Stratos FPV
Model flying wing "Stratos-FPV" was designed as a platform for FPV. The model with a huge bearing surface has a large capacity. It has a large, hollow hull which can easily accommodate equipment FPV + 2 Battery 2200mAh (drive) + 1 1000mAh battery (power video). The hull from the top job of servicing a large flap for easy access to the plant (assembly FPV supplies and equipment, replacement battery). Underneath the model is the runner for whom we hold the model during launch.
Top model of the hand is very easy. Model glides well, is very agile, has a large speed range. The approach to landing is very slow. Flight time motor with 2 batteries operate at a moderate "gas" is about 30 minutes (not included gliding).
Specifications:
- The model is cut from hard styrofoam cnc machine.
- Span - 1600 mm
- Length - 750 mm
- Weight empty complex model - about 600 g
- Wing area 53 dm2 wing (wing has given wash in geometry). Ailerons are cut off from the panel.
- Take off weight - 1100 g (without accessories with a lighter engine FPV 3530) to 1700g (full FPV + 3 batteries - you can still "slim down" the camera, video transmitter, battery, video).
- Estimated assembly time - 10h
The proposed equipment (not included):
- 3f engine with a thrust of 1,500 g eg motor AerodriveXp TGY + SK Series 1935-1936 10x7 propeller
- 3f controller suitable for motor eg H40A TowerPro
- 2 servos 18 g (for ailerons)
- 4-channel receiver.
- For the control model is needed delta mixer or "radio" with the mixer.
Kit includes:
- All parts CNC cut foam polystyrene (hull - eps200, wings and the tip - eps100)
- slats to strengthen the hull
- plywood on frames and motor
- levers helm + cnc laser-cut steel wire for pushrods
- Non-woven glass on the consoles, the strengthening flap and aileron hinges
- runner of the epp
- winglets with epp
- 3 sheets of parchment to cover the model
- installation guide on CD in the form of descriptions in-law (+ where the center of gravity and how wytrymować initial model)
Kit includes:
- All parts CNC cut foam polystyrene (hull - eps200, wings and the tip - eps100)
- slats to strengthen the hull
- plywood on frames and motor
- levers helm + cnc laser-cut steel wire for pushrods
- Non-woven glass on the consoles, the strengthening flap and aileron hinges
- runner of the epp
- winglets with epp
- 3 sheets of parchment to cover the model
- installation guide on CD in the form of descriptions in-law (+ where the center of gravity and how wytrymować initial model)
